fbpx
  • 39 Ron Parkinson Cres, Caloundra QLD 4551
  • (07) 5390 0300

TROUBLESHOOTING GUIDE

Hot water system hard to light
–       Faulty gas regulator not allowing sufficient gas flow Replace regulator
–       Dust contamination into heater pilot light area Blow out area with compressed air
–       Wind blowing out water heating flame Partially close outer door to shield flame
–       Air in gas line after bottle change Bleed air from gas line by starting the stove and or bleed air from the system using the bleed screw on the side of the HWS (contact AOR if attempting this).
Water pump pulses or won’t turn off automatically
–       Head pressure of pump incorrect Contact AOR for adjustment procedure
–       Air leak in suction side of pump Check all filters/fittings and hose clamps
–       Water leak in plumbing system Check all internal/external hoses/taps for leaks.
*Please note the water pump can be isolated at the isolation switch on the main control panel.
No 240 volt mains power in trailer power points Ensure power cord is switched on and inserted firmly into inlet socket.
Check 240 volt safety switch has not tripped. (This occurs occasionally on rough roads).
No 240 volt power available from inverter circuit Ensure inverter is switched on at control switch.
Check inverter mega fuse in electrical compartment.

Check 240 volt inverter safety switch has not tripped. (This occurs occasionally on rough roads)

 

No 12 volt power in trailer Check 30 amp main fuse in fuse box and both the resettable circuit breakers
Check battery terminals are tight.
Macerator toilet fuse blowing Check 30 amp toilet fuse in fuse box.
Check main 30 amp fuse in fuse box.
Reverse flush pump out outlet using the short hose supplied as the impellor could possibly be jammed with waste (Black tank pump only).